ACS 200 MRSA Kill Time Study
Test Solution: ACS 200 Submitted August 19, 2008
September 4, 2008
Results RNA®, LLC
Richard A. Robison, Ph.D.
Department of Microbiology
Brigham Young University
The purpose of this study was to determine the antimicrobial activity of ACS 200 on methicillinresistant Staphylococcus aureus (MRSA). This was accomplished by performing a standard kill-time suspension test using 1, 3, and 5 minute contact times.
II. MATERIALS AND METHODS
A. Test organism
The test suspension was prepared by growing a 5 ml culture of Methicillin-resistant Staphylococcus aureus, ATCC 43300 in Trypticase Soy Broth at 37 oC for 20 hr. Five ml of culture was pelleted by centrifugation, washed with five ml sterile 18 M? water, centrifuged again, and re-suspended in a final volume of two ml sterile water.
The Neutralizer solution consisted of 9 ml tubes of 12.7 % Tween 80, 6.0 % Tamol, 1.7 % lecithin, 1 % Peptone, 1.0 % Cysteine and 500 mM Tris (pH 7.0).
C. Kill-Time Procedure
- A tube (50 ml polypropylene sterile centrifuge tube) containing 9.9 ml of ACS 200 was equilibrated in a 20 °C water bath. At time zero, 0.1 ml of the MRSA suspension was added.
- After the specified contact times, one ml of S. aureus /ACS 200 disinfectant suspension was removed to 9.0 ml of neutralizer. The tube was mixed thoroughly.
- After two minutes, the neutralized suspension was serially diluted 1:10, in physiological saline solution (PSS).
- The number of viable organisms in selected dilution tubes was assayed by membrane filtration. One ml aliquots were plated in duplicate. The membranes were washed with about 100 ml of sterile PSS and removed to Columbia Agar plates. The plates were incubated at 37 °C for 24 and 48 hours.
- The number of colonies on each filter was counted and log reduction and percent kill values were computed.
- A titer of the test suspension was computed by performing membrane filtration assays on selected 1:10 dilutions in PSS of the test suspension.
- A neutralizer control for each disinfectant was performed by inoculating a mixture of 9.0 ml of neutralizer and 1 ml of ACS 200 disinfectant with 0.1 ml of the 1:1x105 dilution of the titer. This produced about 215 CFU / ml in the tube, which was allowed to stand for 20 minutes prior to dilution and assay by membrane filtration using duplicate 1 ml samples.
III. RESULTS Methicillin-resistant Staphylococcus aureus: Titer
Number of colonies:
(Received 8/19/08) Dilution of S. aureus /ACS 200 disinfectant suspension:
|Neutralization Control||Expected Counts:||Percent of Expected:|
Results of the titer showed a viable S. aureus concentration of 2.17 x 109 organisms per ml in the original suspension. Inoculation of 9.9 ml of ACS 200 disinfectant with 0.1 ml of this suspension produced an initial concentration of 2.17 x 107 S. aureus per ml in the assay tube.
Results from these procedures allowed log reduction (LR) and percent kill (PK) values to be calculated using the formulas: 1) LR = -Log(S/So); where S = concentration of viable organisms after the specified contact time; and So = the initial concentration of viable organisms at time zero. 2) PK = (1 - (S/So)) x 100. These values are shown below.
|Solution||Contact Time||Log Reduction (LR)||Percent Kill (PC)|
|ACS 200||1 min.||3.92||99.988|
Neutralization control data revealed that the neutralizer was able to adequately neutralize ACS 200. Observed counts were 200 percent of those expected.
ACS 200 had excellent bactericidal activity against methicillin-resistant S. aureus, producing a 3.92 log reduction in one minute and complete kill (>6.6 log reduction) within 3 minutes.
Test Dates: August 22 -24, 2008
Please Note: This report does not constitute endorsement by Richard A. Robison or Brigham Young University, of the tested products in any way. The names 'Richard A. Robison' and/or 'Brigham Young University' may not be used in any type of promotional published material, either written or electronic, without express written permission from both parties.